解除底线余量调整计数器的计数的方法; Releasing Procedure Of The Bobbin Thread Remaining Amount Detection Count-Up - Jack JK-T5878-58G Instruction Manual

设定计数器画面(画面A)
Counter setting screen(screenA)
设定底线余量调整值画面(画面B)
Bobbin thread remaining amount
adjustment value setting screen
(screen B)
(2) 解除底线余量调整计数器的计数的方法

Releasing procedure of the bobbin thread remaining amount detection count-up

3) 设定底线余量调整值
按了调整底线余量调整值按钮
画面(画面B)被显示出来。
Set the bobbin thread remaining amount adjustment value
Press BOBBIN THREAD REMAINING AMOUNT ADJUSTMENT
VALUE SETTING button
amount adjustment value setting screen (screen B) is displayed.
这时，请输入底线余量调整值(50～57000)。
底线余量值是指一个梭芯绕满后上面线的总长。
・余量发生下列情况时，需要重新调整。
1．更换新的梭芯时
2．底线线号变更后
・输入了底线余量调整计数器值之后原来的底线余量计数器
值被清除。
Here, input the bobbin thread remaining amount adjustment value
（50~57000）
The bobbin thread remaining amount refers to the overall
length of thread when the bobbin is full.
When any of the following conditions occurs,the bobbin
thread remaining amount needs readjusting.
1. Replacement of the bobbin
2. Changeover the bobbin thread size
Inputing the new value
remaining amount value will be cleared.
缝制结束时，底线余量计数器值达到0的话，显示计数画面，蜂鸣器鸣
响。请更换梭芯。
○
按了清除按钮 A 之后，复位底线余量计数器值，然后返回缝制画
面。
When the bobbin thread remaining amount counter value becomes "0" at the
sewing end, the count-up screen is displayed and the buzzer sounds. Replace
the bobbin thread of the bobbin.
When CLEAR button
amount counter value is reset and the screen returns to the sewing screen.
22
○
C 之后，设定底线余量调整值
○
C and the bobbin thread remaining
and he
t primary
,
○
A is pressed, the bobbin thread remaining
bobbin thread