Table of Contents
Advertisement
Install Accessories
15. Install the Oil Tunnel {G} into recess support near
rear of hood. Refer to Figure 19.
16. Install Baffle Filters {H} and Stainless Steel Spacers
{I}. ① Angle baffle filter toward back of hood. ②
Push the baffle filter up until almost level. ③ Slide
forward into recess behind the front of hood. ④
Lower baffle filter. ⑤ Slide back until it fits into
resting position. Refer to Figure 20.
17. For Stainless Steel Spacer, follow above steps.
Final Installation
18. Turn power ON in control panel. Check all lights
and fan operation
19. Make sure to leave this manual for the homeowner.
Figure 19
Figure 20
12
Advertisement
Table of Contents
