Table of Contents
Advertisement
Ductwork Installation
10. Use steel pipe to connect the exhaust on the hood
to the ductwork. Use duct tape to make all joints
secure and air tight.
Install Accessories
11. Install the Oil Tunnel {G} into recess support near
rear of hood. Refer to Figure 7.
12. Install Baffle Filters {H} and Stainless Steel Spacers
{I}.
Angle baffle filter toward back of hood.
Push the baffle filter up until almost level.
forward into recess behind the front of hood.
Lower baffle filter.
resting position. Refer to Figure 8.
13. For Stainless Steel Spacer, follow above steps.
Final Installation
14. Turn power ON in control panel. Check all lights
and fan operation.
15. Make sure to leave this manual for the homeowner.
Slide back until it fits into
Figure 7
Figure 8
Slide
8
Advertisement
Table of Contents
