Webb WEH12R Original Instructions Manual page 13

FITTING THE GRASS COLLECTOR
1. To fit the grass collector to your lawnmower, position the two hooks on the bottom of your grass collector
assembly, between the front roller and cutting cylinder, using the two hooks to locate and slot inside the
two inner plates.
SETTING UP YOUR CYLINDER
CAUTION
This operation must be undertaken close to the cutting cylinder blade. We strongly recommend the use of
thick gardening gloves on both hands and the lawnmower body is secured to stop the cutting cylinder blade
from rotating.
1. The fixed bottom blade must be set correctly for the lawnmower to work efficiently.
2. Carefully tighten the two top "Click" adjusting knobs, by turning them in small increments, in a clockwise
direction.
3. Each click moves the cylinder by 0.05mm.
4. When the cylinder blade contacts the fixed bottom blade, turn the "Click" adjusting knob anti-clockwise,
until you can rotate the cylinder cutting blade and you can hear light contact with the fixed bottom blade.
5. To check the machine is cutting correctly, place a piece of good quality paper, along the whole length of
the fixed bottom blade (from underneath the lawnmower), with each of the five cutting blades. This
should provide evidence of a good even cut.
13