Onkyo TX-NR797 Instruction Manual page 141

Setting Item Default Value
Loudness Plus On
„ 8. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value
Speaker On
Virtualizer
Setting Details
When this is set to "On", you can enjoy even subtle
nuances of audio expression at low volume. This
is only available when the THX listening mode is
selected.
THX Loudness Plus
THX Loudness Plus is a new volume control
technology mounted on THX Ultra and THX Select-
certified receivers.
With THX Loudness Plus, home theater audience
can experience the rich details of surround sound
at any volume level.
If the volume is turned down below the reference
level, elements of sound in a certain range are lost
or the sound is perceived differently by the listener.
THX Loudness Plus compensates for the tonal and
spatial shifts that occur when the volume level is
reduced, by intelligently adjusting the levels of the
surround channels and their frequency response in
the environment.
This enables users to experience the true impact
of soundtracks regardless of the volume setting.
THX Loudness Plus is automatically applied when
listening in any THX listening mode. In the newly
developed THX Cinema, THX Music and THX
Games modes, the optimum THX Loudness Plus
setting is applied according to the type of content.
Setting Details
"On": Listening modes such as T-D that have virtual
speaker effects can be selected.
"Off": Listening modes such as T-D that have virtual
speaker effects cannot be selected.
Contents Connections
≫
3. Audio Adjust
„ 1. Multiplex/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value
Multiplex Input Main
Channel
Mono Input Left + Right
Channel
Mono Output Center
Speaker
141
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit's display.
Set the input channel when playing in Mono
listening mode digital signals such as Dolby Digital
or analog/PCM signals recorded in 2 channels.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Set the speaker to output monaural audio in the
Mono listening mode.
"Center": Audio is output from the center speaker.
"Left/Right": Audio is output from the front L/R
speakers.
• If the item cannot be selected even though
connection is correct, check if the setting in
"2. Speaker" - "Configuration" - "Speaker
Channels" matches the number of connected
channels.
≫