Onkyo TX-NR797 Instruction Manual page 136

Setting Item Default Value Setting Details
Zone 2 Lineout Zone 2 Set an output destination of the audio output from
ZONE 2 LINE OUT/ZONE B LINE OUT jack.
"Zone 2": When connecting a pre-main amplifier in
a separate room (ZONE 2)
"Zone B": When connecting a pre-main amplifier,
transmitter of wireless headphones, etc. to ZONE B
• This setting is fixed to "Zone 2" when "Zone
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This setting will be set to "No" in either of
Speaker 6 ohms or above Set the impedance (Ω) of the connected speakers.
Impedance "4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When all the connected
speakers have an impedance of 6 Ω or more
• For impedance, check the indications on the
Contents
Speaker" is set to "Zone 2" or "Zone 2/Zone 3".
following cases.
– When 2 sets of height speakers are used
– When surround back speakers and height
speakers are being used at the same time.
– When "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3"
back of the speakers or their instruction manual.
Connections
≫
„ 2. Crossover
Change the settings of crossover frequencies.
• As for the THX-certified speakers, the following settings are recommended.
– Crossover frequency → "80 Hz (THX)"
– "LPF of LFE" → "80 Hz"
– "Double Bass" → "Off"
Setting Item Default Value
Front 80 Hz (THX)
Center 80 Hz (THX)
Height 1 80 Hz (THX)
136
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• If "Configuration" - "Subwoofer" is set to "No",
"Front" is fixed to "Full Band", and the low
pitched range of the other channels is output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
≫