ABB TPS 61D01 Operation Manual page 81

Operation Manual / TPS48-D/E.. - TPS61-D/E..
8 Disassembly and assembly / 8.1 Introduction
© Copyright 2020 . All rights reserved.
Oil orifice
When disassembling the turbocharger, a fitted oil orifice must not be
u
removed.
Tightening torques for turbocharger components
The specified tightening torques of screw connections for turbocharger
components must be observed (see section Table of tightening
torques).
Tightening torques for assembly devices from ABB
Unless otherwise described, the screws and nuts of the assembly
devices must be secured so they are tight-fitting.
WARNING
Suspended loads
Loads not suspended in compliance with regulations may lead to per-
sonal injury or accidents with fatal consequences.
Attach turbochargers, assemblies or individual components only to
u
lifting gear which is in technically perfect condition and has a suffi-
cient load limit.
Make sure the load is suspended properly on the crane hook.
u
Do not let anyone stand beneath a suspended load.
u
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
Definition of terms
¡
Suspension point
Defined load attachment point on a component or an assembly (blind
hole thread, eye, lug).
¡
Assembly device
Devices that are fitted on the turbocharger in order to obtain a sus-
pension point. Assembly devices are specially constructed and de-
signed for the defined use; they are not commercially available
products. Use assembly devices only for the described applications.
¡
Lifting gear
Equipment for lifting and transporting loads (lifting slings, chain
block, crane). Lifting gear is not supplied by ABB.
HZTL2410_EN Rev.F March 2020