REMOVING THE UPPER HEAT SHOE
Remove the upper heat shoe to gain access
to the laminating rollers for cleaning.
• Unplug laminator and allow it to cool
to room temperature.
• Remove upper cooling fans.
• Rotate front roller release knob to its full counter-
clockwise position.
• Lift front of heat shoe and unhook from hangers.
• Rotate front roller release knob to its full clockwise
position.
• Place towel or other padded material on feed table.
• Grab the rear of the heat shoe and rotate it over so
that the heat shoe is upside-down.
• Rest heat shoe on feed table.
CAUTION: Use care and do not pull on or
put excessive stress on heat shoe wires.
To re-install heat shoe, reverse the above procedure.
20
USI • YOUR SOURCE FOR LAMINATION
Remove cooling fans.
Unhook heat shoe from hangers.
Rest heat shoe on cushioned feed table.
Photo 18B.
Photo 18C.
Photo 18D.