Roller Lifts - usi MRL Series Operation And Maintenance Manual

ROLLER LIFTS

The roller lifts should be set to full pressure
(rotated fully clockwise) for most encapsulation
laminating.
For laminating stock 1/8" or thicker, release the
roller lifts by rotating counterclockwise. The lamination
should be loaded and heated. Using a 12" x 25" scrap
piece of the substrate stock that you will be laminating,
push material through the rollers (at the same time you
will be pushing the film). Stop when approximately 1" of
board is pertruding out in front of the heat shoes.
Lock roller lifts down one quarter turn past the contact
point. Note: Document should not be crushed.
To laminate, butt the substrate piece to be laminated
up against the scrap piece. Turn the drive to a slow
speed and push the substrate into the laminator
while keeping it butted up against the scrap. The
scrap and the substrate will run through. Once the
pressure has been set, it does not need to be reset
until the thickness of the substrate changes.
Roller lift knob adjustments allow for
lamination of thicker substrates.
Adjusting the roller lifts to fit specified thickness.
YOUR SOURCE FOR LAMINATION • USI
Photo 13A.
Photo 13B.
13