Automatic Reverse Feature - usi MRL Series Operation And Maintenance Manual

AUTOMATIC REVERSE FEATURE

Use the automatic reverse feature if laminating film gets
wrapped around the rubber roller. Proper care and attention
during operation minimizes the need for the use of the
reverse feature. However if a "wrap-around" does occur
follow these instructions.
NOTE: Excessive film wrap around will cause
equipment damage.
• Remove the feed tray and cut the film web top
and bottom where it wraps around the idler bars.
• Firmly grasp the film web.
Be careful to stay clear of the hot heat shoes.
• Turn the speed control knob to a slow speed
and depress the reverse switch. Slowly back
the film out of the laminator.
• When clear, reload the laminating film.
WARNING: Never use a sharp object to cut laminating
film on the rubber rollers. Any damage to the rollers will
leave a permanent impression on the lamination and
require roller replacement.
NOTE: To assist in removing jammed film, you can
release the roller pressure. Rotate the roller lift knobs
counterclockwise and remove film. Reset the pressure.
Automatic reverse switch.
Cut top and bottom film webs
where they wrap around idler bars.
Grasp the cut film and gently pull as the
laminator runs in reverse at a very slow speed.
YOUR SOURCE FOR LAMINATION • USI 15
Photo 14A.
Photo 14B.
Photo 14C.