Table of Contents
Advertisement
RE-LOADING A NEW SUPPLY OF
FILM
ON A HOT LAMINATOR
Allow the old film to run to a point just before it pulls off the
supply rolls. Turn the drive switch to "OFF."
Cut the film web with a blade so that approximately 5" of film
extends beyond each idler bar.
CAUTION: When using a sharp object to cut film (blade or
shears), avoid contact with heat shoes or rubber rollers.
• Remove the old cores and replace with
new rolls of film.
• Loosen the tension on the film rolls.
Thread the new web of film around the idler
bar and tape it to the remaining segment of
the expended roll.
• Run film through the laminator until the
new web of film clears the pull rollers.
18
USI • YOUR SOURCE FOR LAMINATION
Photo 16A.
Cut the film web, leaving approx. 5" of film
extended beyond the idler bar.
Photo 16B.
Tape new film web to remaining
segment of previous film roll.
Photo 16C.
Run laminator until clear film exits.
Advertisement
Table of Contents
