Time Guard ProgramaSTAT UFPT24 Operating Instructions Manual page 6

1 To Reset Before Programming
(To alter clock time or modify programmes - see section 5)
To clear programmes from memory and reset the
UFPT24 press and hold down both buttons until the
display goes blank. Release buttons and display will fill
with its complete range of characters and then clear to
show clock and hour digit flashing. This procedure is
essential on installation and recommended if major
reprogramming is required subsequently.
You are now in the clock setting mode
at the beginning of the programme sequence
Programming sequence
5
Programme 1 OFF
Programme 2 OFF
Note: Pauses between button presses greater than 1 minute during programming will
result in automatic return to the operating mode.
2 Setting Clock (after reset)
i Hour Setting - Press the <Change> button to advance the
hour setting. For rapid hour selections press and hold
down <Change> button.
Setting clock
Programme 1 ON
Programme 2 ON
. . . . ➔
:
Programme 3 ON
:
Programme 3 OFF
:
Programme 4 ON
:
:
Programme 4 OFF
:
. . . . . . Operating Mode
1 2 3 4
1 2 3 4