Normal Operating Mode - Time Guard ProgramaSTAT UFPT24 Operating Instructions Manual

Normal Operating Mode

In normal operation the UPFT7 will display the correct day and its time with the colon
flashing. The output status will be shown by either ON or OFF on the display.
1 To Reset Before Programming
(To alter clock time or modify programmes - see section 5)
To clear programmes from memory and reset the UPFT7
press and hold down both buttons until the display goes
blank. Release buttons and display will fill with its
complete range of characters and then clear to show clock
and day 1 symbol flashing. This procedure is essential on
installation and is recommended if major reprogramming
is required subsequently.
9
You are now in the clock setting mode at the beginning
of the programme sequence
Programming sequence
Programme 1 OFF
Programme 2 OFF
Programme 3 OFF
Note: Pauses between button presses greater than 1 minute during
programming will result in automatic return to the operating mode.
Setting clock
Programme 1 ON
Programme 2 ON
Programme 3 ON
. . . . ➔
Programme 4 ON
:
:
Programme 4 OFF
:
Programme 5 ON
:
Programme 5 OFF
:
Programme 6 ON
:
:
Programme 6 OFF
:
. . . . . .
Operation Mode
OFF
1 2 3 4 5 6 7
1 2 3 4 5 6 7