Step 3; Step 4 - modway Conduit EEI-2799 Manual

EEI–2799/2800

STEP 3:

Put Bar Stool Front (3) to the assembled Bar Stool Back (1) , Bar Stool Seat (2) , and Stretchers (4) as shown.
Insert 4 pieces of Long Bolt (B) with 4 pieces of Flat Washer (C) into the holes on Bar Stool Front (3) through the holes on
Bar Stool Seat (2) .
Insert 4 pieces of Short Bolt (A) with 4 pieces of Flat Washer (C) into the holes on Bar Stool Back (1) through the holes on
Stretchers (4).
Use Allen Wrench (D) to tighten all the Short Bolts (A) and Long Bolts (B). Do not fully tighten the Bolts (A&B) at this step.
C
A
D
Ax4

STEP 4:

Carefully turn over the assembled Bar Stool.
Please put a heavy object or seat one adult on top of the assembled Bar Stool to press the bar stool for leveling.
Use Allen Wrench (D) to tighten all the Short Bolts (A) and Long Bolts (B) clockwise until secure.
Assembly is complete. Your Bar Stool are ready to be used now!
Dx1
Customer Service 908-368-1025︱www.modwayfurniture.com
BAR STOOL
B
C
C
A
Bx4 Cx8
D
3
B
C
Dx1
1
2
Hardware & Tool required
Hardware & Tool required
Page 3 of 4