Advertisement
Table of Contents
EEI-3061 BENCH
Thank you for purchasing the MODWAY BENCH.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 20 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
Components:
1
Bench Body x1
Customer Service 908-368-1025︱www.modway.com
2 Leg x 2
3 L
eg stretcher
A.
Bolt M8x 65mm
B.
Bolt M8x 45mm
C.
Spring Washer
D.
Flat Washer x 12
E.
Allen Wrench
x 4
4 Leg x2
x 8
x 4
x 12
x1
Page 1 of 4
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for modway Adept EEI-3061
Summary of Contents for modway Adept EEI-3061
- Page 1 EEI-3061 BENCH Thank you for purchasing the MODWAY BENCH. Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 Attach 1 piece of Leg (2) to the bottom of Bench Body (1) by using 2 pieces of Bolts (A) with 2 pieces of Spring Washer (C) and 2 pieces of Flat Washer (D) as shown. Tighten Bolts (A) by using Allen Wrench (E) as shown. Hardware & Tools required Customer Service 908-368-1025︱www.modway.com Page 2 of 4...
- Page 3 Repeat the same steps for other pieces of Leg (2) & Leg Stretcher (3) and Leg (4) & Leg Stretcher (3). Place Legs (2&4) to the right postion as shown. Hardware & Tools required Customer Service 908-368-1025︱www.modway.com Page 3 of 4...
- Page 4 Close the zipper on the bottom of the Bench Body (1). Carefully turn over the assembled Bench Body (1) and Legs (2) & Leg Stretcher (3) as shown. Assembly is complete. Your Bench is ready to be used now! Customer Service 908-368-1025︱www.modway.com Page 4 of 4...
Need help?
Do you have a question about the Adept EEI-3061 and is the answer not in the manual?
Questions and answers