Return To The Factory Settings - Dunkirk DMG-240 Installation, Operation & Maintenance Manual

9.18 Return To The Factory Settings:

• Press the two Menu buttons
then (+) button until
bar.
• Select the INSTALLER menu using
appears on the display.
• Use (-) or (+) button to input the installer code
"0012".
• Confirm using
flashing.
• Press the [+] button several times p:df is displayed
with df flashing.
• Press button df:x is displayed with x flashing.
This is the current value of X for dF. Check this against
the value of X on the type plate.
• Enter the value of X shown on the type plate using the
[-] or [+] button.
• Confirm the value with the
displayed with y flashing. This is the current value of Y
for dU. Verify the value of y on the rating plate is the
same.
• Enter the value of y shown on the rating plate using the
[-] or [+] button.
• Confirm value with the
settings are reset.
• Display returns to current operating mode.
9 - START UP PROCEDURE
simultaneously and
symbol flashes on the menu
. "COdE"
button. P:1 is displayed with 1
button, df:y is
button. The factory
3x
-
...x
-
-
61
dF =1 dU =1
P/N 240011656, Rev. E [07/30/2018]