Frontlightgroup - PIAGGIO X7 125 2012 Manual

Tail light and stop light bulb
License plate bulb
Type: SPHERICAL, TWIN-
FILAMENT
Power: 12V - 5/21W
Quantity: 2
Type: ALL GLASS
Power: 12V - 5W
Quantity: 1

Frontlightgroup (03_27, 03_28, 03_29, 03_30, 03_31)

To access the bulbs:
1. Remove the PIAGGIO clip-on badge and undo screw «A».
2. Working on both sides of the vehicle undo screw «B» and remove the front headlight
cover.
3. Undo the three screws «C» and the two screws «D» located inside the front mud-
guard from both sides of the vehicle.
4. Take the headlight assembly off its housing.
03_27
To reassemble, repeat the operation in the reverse order.
To replace the tail light bulbs «E», take out the rubber bulb holder and slide off the
bulb.
In order to replace the high-beam «F» and low-beam «G» bulbs, remove the rubber
cap, take out the bulb holder by releasing the springs and slide off the light bulb.
In order to replace the turn indicator bulbs «H», take out the right bulb holder by turning
it anticlockwise, or clockwise, if it is the left one, and then slide off the bulb by pushing
and turning it anticlockwise.
59