Sd Card; Operating And Error Displays; Conf" Pushbutton; Led - Bosch Rexroth IndraControl XFE01.1-SY-01 Operating Instructions Manual

30/41
Device description

12.1 SD card

The application program (boot application), user management data as well as
two logbooks (devices and application) are stored on an SD card and also re-
main if the power supply fails.

12.2 Operating and error displays

12.2.1 "Conf" pushbutton

Press the "Conf" pushbutton once to confirm the established communication be-
tween the programming system and the Safety extension module upon initial
login. This confirmation ensures that you are only connected to the selected
Safety extension module IndraControl XFE01.1-SY-01 and not accidentally to a
different Safety module.

12.2.2 LED

The display LED indicates the following:
LED Color and status
Pwr Off
Red
Green
Error Off
Red
Tab. 12-1: LEDs to display operational readiness
LED "Run" LED "Failure"
(Color and status) (Color and status)
Off Off
Off Green
Red Off
Bosch Rexroth AG R911376654_Edition 04
IndraControl XFE01.1-SY-01 Safety Ex-
Description
No power supply from the standard control present
Error: The voltage monitoring of the Safety function module
IndraControl XFE01.1-SY-01 switched off the safe logic volt-
age
All internal voltages of the Safety extension module
IndraControl XFE01.1-SY-01 are within the permitted range
The Safety extension module IndraControl XFE01.1-SY-01 is
ready
The Safety extension module IndraControl XFE01.1-SY-01 is
not ready. This LED is on during the initialization phase.
If the LED is still on after the initialization (approx. 1 min) or
if the LED is permanently switched on at runtime, integrated
self-tests determined a "fatal error" (e.g. hardware error).
The Safety extension module IndraControl XFE01.1-SY-01 is
then probably defective and has to be replaced.
Contact the Bosch Rexroth Service
Operating state of the Safety extension module IndraControl
XFE01.1-SY-01
No power supply provided or hardware reset triggered
Initialization phase; first part (ca. 30 s) is running
Initialization phase; second part (ca. 10 s) is running
tension Module