RadioLink EIB168RC Instructions Manual page 8

To House Code, insert a small screwdriver
INSERT SCREWDRIVER TO
into the House Code switch slot and remove
TURN ON HOUSE CODE SWITCH
immediately when blue light comes on. Repeat
this for all alarms in the system. This must be
completed as quickly as possible to activate the
House Code mode and ensure the system only
communicates with itself and not neighbouring
BLUE LIGHT
systems.
It is essential that the RadioLINK Bases are House Coded.
Press and hold the Button to test each Alarm.
Check that the red light is flashing, the horn is
sounding. To ensure the Alarm is communicating
with others check that the blue light comes on
for approx 3 seconds.
Before testing the next alarm allow a minimum
of one minute after the last alarm has stopped
sounding from the previous test.
This guide is for quick referencing only. You must read the user manual
thoroughly before installation and use.
7