Table of Contents
Advertisement
To prevent air draughts affecting smoke or heat
entering the alarm it is important to seal the
area around the hole in the ceiling with foam
or silicon rubber.
Screw the base to the ceiling using a single
screw for now. The second screw should be
inserted at the end of this procedure to secure
the base permanently.
Connect the wiring to the terminal block as
shown here.
L: Live - connect to the house wires coloured
brown, or marked L.
N: Neutral - connect to the house wires coloured
blue, or marked N.
IC: (Hardwire Interconnect- Only used to bridge
a mixed wired and wireless system)
Insert second screw and tighten both screws on the base and replace the terminal cover.
11
Advertisement
Table of Contents
