Table of Contents
Advertisement
A maximum of 12 RadioLink bases may be used in any one system. If your system has more
than 12 Alarms please consult your supplier or contact tech support (see back page).
When all the RadioLINK bases have been installed and fitted with Alarms, you are
now ready to house code the system.
It is essential to House Code the RadioLINK Bases to ensure they will
not accidently communicate with nearby systems. Failure to house
code the system may also result in a system malfunction.
Press and hold the House Code switch on the
side of any one of the RadioLINK Bases with a
small screwdriver until the blue light illuminates.
Immediately release the switch and the blue light
will flash quickly and then stop. The flashing will
repeat every 5 to 10 seconds thereafter.
Repeat this procedure for all Alarms in the system.
Any additional RadioLINK devices being used in
the system, e.g. EIB450 remote controller must
also be included in the house coding. For house
coding instructions of RadioLINK devices consult
their manuals.
House Coding
WARNING
HOUSE CODE SWITCH
BLUE LIGHT
13
Advertisement
Table of Contents
