Table of Contents
Advertisement
Check that all the devices have been successfully
house coded.
This can be done by counting the amount
of blue flashes on each RadioLINK base. The
number of flashes should correspond to the
number of devices in the system. e.g. if the
system has 4 Alarms and a remote controller
(e.g. EIB450) the blue light on each base will
flash 5 times and repeat this pattern every 5 to
10 seconds.
To complete the commissioning, the system
must exit house code mode.
The units will automatically exit house code
after 30 minutes. Once the house coding is
completed the system will not communicate
with any other RadioLINK devices.
The house code procedure can also be
terminated on demand. To do this, press the
house code button on one of the bases. When
the blue light comes on solid release the button.
This unit will then send a signal to all the other
14
Advertisement
Table of Contents
