Operating The Quick Stick - Toro Power Max e26 Operator's Manual

operate the machine. Check the auger/impeller
cable; refer to Checking and Adjusting the
Auger/Impeller Cable (page 25)
necessary. Otherwise, take the machine to an
Authorized Service Dealer for service.
WARNING
If the auger and impeller continue
to rotate when you release the
auger/impeller lever, you could seriously
injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.
Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
and adjust it if
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute
and chute deflector into position
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the
left; move the Quick Stick to the right to move the
discharge chute to the right
•
•
•
20
Figure 24
Figure 25
If the chute does not move, refer to
Discharge-Chute Latch (page
If the chute does not turn as far to the left as it
does to the right, ensure that the cable is routed to
the inside of the handles. Refer to
Upper Handle (page 9).
If the chute does not lock into place when you
release the trigger cap, refer to
Discharge-Chute Latch (page
(Figure 24).
g001014
(Figure 25).
g018894
Adjusting the
27).
2 Installing the
Adjusting the
27).