Operation; Before Operation; Installing The Battery Pack; Turning On The Headlight And Handwarmers - Toro Power Max e26 Operator's Manual

Operation

Before Operation

Installing the Battery Pack

1. Ensure that the vents on the battery packs are
clear of any dust and debris.
2. Lift up the battery-compartment lid.
3. Line up the cavity in the battery pack with the
tongue on the machine and slide the battery
pack into the compartment until it lock into place
(Figure 9).
4. Close the battery-compartment lid.
5. Repeat for the other 2 battery cavities (if
needed).
Note:
The combined amp hours of all the
installed batteries must add up to 6.0 or greater,
otherwise the machine can not start.
Note:
If the battery-compartment lid does not
close completely, the battery is not fully installed.
Figure 15
Turning On the Headlight
and Handwarmers
You can turn on the power to the hand warmers and
the headlight before operating the machine; turn the
key to the A
CCESSORY
In the A
CCESSORY
state of charge of each installed battery. The position
of each set of lights corresponds to the related battery
cavity. If the battery state of charge is too low and
needs to be charged, or if there is no battery in the
corresponding cavity, the battery presence light does
not turn on.
1. State-of-charge lights
2. Battery presence lights
g344093
16
position (Figure 16).
position you can also view the exact
Figure 16
3. Key switch in the
A
CCESSORY
g348182
position