Product Overview - Toro Power Max e26 Operator's Manual

Figure 10
The machine should move rearward. If the
machine does not move or moves forward,
complete the following:
A. Release the traction lever and shut off the
machine; refer to
(page 22).
B. Disconnect the trunnion from the
speed-selector lever.
C. Turn the trunnion downward (clockwise) on
the speed-control rod.
D. Connect the trunnion to the speed-selector
lever.
4. Release the traction lever.
5. Move the speed selector to Position 1; refer to
Operating the Speed Selector (page
6. Squeeze the left (traction) lever to the handgrip
(Figure 10).
The machine should move forward. If the
machine does not move or moves rearward,
complete the following:
A. Release the traction lever and shut off the
machine.
B. Disconnect the trunnion from the
speed-selector lever.
C. Turn the trunnion upward (counterclockwise)
on the speed-control rod.
D. Connect the trunnion to the speed-selector
lever.
7. If you made any adjustments, repeat this
procedure until no adjustments are required.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 24)
to an Authorized Service Dealer for service.
Shutting Off the Machine
19).
Checking and Adjusting
or take the machine

Product Overview

g001011
1. Handgrip (2)
2. Auger/impeller lever
3. Lock switch
4. Speed-selector lever
5. Handwarmer switch
6. Quick Stick ®
discharge-chute control
7. Traction lever
8. Main battery-compartment
lid
9. Electric-start key
14
Figure 11
10. Chute deflector
11. Discharge chute
12. Scraper
13. Auger
14. Skid (2)
15. Control panel
16. Secondary
battery-compartment
lid
17. Snow-cleanout tool
18. Headlight
g361064