Checking The Tire Pressure; Checking The Skids And Scraper; Adjusting The Auger/Impeller Cable; Checking The Operation Of The Traction - Toro Power Max e26 Operator's Manual

7

Checking the Tire Pressure

No Parts Required
Procedure
8
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to Checking and Adjusting the Skids and
Scraper (page 23).
9
Adjusting the
Auger/Impeller Cable
No Parts Required
Procedure
Check and adjust the auger/impeller cable before first
use; refer to

9 Adjusting the Auger/Impeller Cable

(page 13).
10
Checking the Operation of
the Traction Drive
No Parts Required
Procedure
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust it
properly, if necessary.
1. Start the machine; refer to
(page 17).
2. Move the speed selector to Position R1; refer to
Operating the Speed Selector (page
3. Squeeze the left (traction) lever to the handgrip
(Figure 10).
13
g344084
Starting the Machine
19).