Advertisement
1. ASSEMBLY INSTRUCTIONS
You will need:
1. An adjustable wrench
2. A Phillips head screwdriver
1. Remove all components from the box and individual packaging.
2. Turn base frame upside down.
3. Leg Attachment:
a. Align the leg holes with the corresponding frame holes to achieve desired height
(12" or 25").
b. Attach long bolts, washers and nuts.
c. Tighten with wrench.
4. Shelf Attachment:
a. Align holes in shelf with guide slots on frame.
b. Insert a short bolt through the shelf and frame on the front of the unit, and one
through the shelf and frame on the back of the unit.
c. Attach washer and nut.
d. Tighten with wrench; be careful not to over-tighten so that shelf may slide.
e. Repeat Steps A through D for second shelf.
5. Hose to Burner Attachment:
a. If the air shutter is not already attached to the burner with screws, align the air
control disc over the end of the burner.
b. Burner's screws may need tightening; be careful not to over-tighten.
c. Attach each burner to dual gas connector by inserting threaded end into burner's
faceplate and turn clockwise to tighten.
d. Insert brass hose connector into dual gas connector.
e. Turn hose connector clockwise with wrench until snug; be careful not to
over-tighten.
6. Burner Attachment:
a. Remove nuts and washers from each burner's bottom.
b. Align each burner's bolt to the corresponding hole in the crossbar.
c. Insert the burner's bolt into the crossbar
d. Attach washer and nut.
e. Tighten with wrench.
7. Return base frame upright.
3
Advertisement
