Precautions for Safe Operation
Avoid looking directly into the laser beam or at specular reflection, even with
Wear laser safety eyewear that is optically dense at the wavelengths of
Provide a controlled access area for laser operation and limit access to those
Post warning signs in prominent locations near the laser operation area.
Use safety interlocks on all entryways. All Northrop Grumman system control
Enclose beam paths wherever possible.
Set up experiments so the laser beam is below eye level.
Work in an area that is well lighted to avoid dilation of pupils.
Set up a target for the beam.
Set up shields to prevent reflected beams from escaping the laser operation
View an infrared laser beam with a protected image converter at an oblique
Ensure that all electrical connections are made in a safe manner.
Position equipment so that electrical connections are shielded from accidental
Do not smoke, eat, or drink in laser areas.
Avoid leaving an operating laser unattended.
Center for Devices and Radiological Health Compliance
This laser (component) contains warning labels, an internal shutter, laser "on" light and
cover interlocks. If it is sold as an OEM laser component, compliance with Title 21 of the
U.S. Code of Federal Regulations, Chapter One, Subchapter J, Part 1040.10 and
1040.11Is dependent on the customer supplied control system. If it is sold with Northrop
Grumman's electronic system, it complies with the regulations.
© 2019 Cutting Edge Optronics, Inc.
Approved for Public Release; NG19-2099
protective eye wear on.
operation (798-816 nm pump light, 1064 nm fundamental, 532 nm second
harmonic).
trained in laser safety principles.
electronics are supplied with interlock inputs that can be used to preclude
operation with an open safety door.
area.
angle reflecting from a diffuse surface.
touch.
8
Chapter 2: Laser Safety
Iklwa Laser User Manual
CEO-UMAN-0055E