Cedar Ridge CRHEB24RT Owner's Operation And Installation Manual page 23

Install Batteries
Batteries are required in both the Remote
Control (Transmitter) (2 AAA size) and Re-
ceiver (4 AA size) (see Figure 27).
Note: Be sure batteries are placed correctly.
Reversing the batteries can cause damage to
the receiver and remote. Replace all batteries
on a yearly basis or sooner.
Receiver
Figure 27 - Installing Batteries in Remote
Control and Receiver
Programming the Remote and
Receiver
The remote and receiver must be "learned"
to one another.
1. Turn control knob on the heater to the ON
position.
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Install/replace the batteries according to the
type and quantity stated in table to the right.
• Do not mix old and new batteries. New bat-
teries should be the same brand for best
results.
200015-01B
OPERATION
REMOTE CONTROL SYSTEM
Remote Control
(Transmitter)
Battery Instructions
www.usaprocom.com
2. Place the slide switch on the receiver in
the remote position (see Figure 28).
3. Use a pen or small screwdriver to gently
press and release the recessed LEARN
button on the face of the receiver. You will
hear a beep.
4. Press the ON button on the remote (see
Figure 28). You will hear a series of beeps.
Your appliance should come on.
Matching Security Codes
When matching security codes, be sure slide
switch on the receiver is in the REMOTE
position. To program the remote receiver
to LEARN a new security code, press and
release the LEARN button on the top of the
remote receiver, and then press ON or OFF
button on the transmitter. A change in the
beeping pattern at the receiver, indicates the
transmitter's code has been programmed into
the receiver.
Learn Button
LEARN
ON
Figure 28 - Receiver
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For remote control systems, maximize bat-
tery life by turning off the receiver when it
is not in use.
• For long periods of non-operation, remove
batteries from all components for safety.
Component
Ignitor
Remote Control
Remote Receiver
*Note: Quantity depends on model of remote
Control.
Slide Switch
REMOTE OFF
Type of Battery Qty.
AAA
AAA 2 or 3*
AA
1
4
23