Cedar Ridge CRHEB24RT Owner's Operation And Installation Manual page 22

9. With control knob pressed in, push
down and release ignitor button. This
will light pilot. The pilot is attached to
the rear of the burner. If needed, keep
pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, refer to
Troubleshooting, pages 29 though 31.
Also contact a qualified service technician
or gas supplier for repairs. Until repairs
are made, light pilot with match. To light
pilot with match, see Manual Lighting
Procedure.
10. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
Note: If pilot goes out, repeat steps 7
through 10. This heater has a safety in-
terlock system. Wait one (1) minute before
lighting pilot again.
11. Turn control knob counterclockwise
to the ON position. The main burner
should light.
Note: Please wait one minute after shut-
ting off heater to allow the control valve
to reset before starting again.
Shutting Off Heater
Turn control knob clockwise
OFF position.
1. Follow steps 1 through 7 under Lighting
Instructions, page 21.
2. With control knob in PILOT position, strike
match, and hold near pilot. Press in control
knob; pilot should light.
22
OPERATION
TO TURN OFF GAS TO APPLIANCE
to the
MANUAL LIGHTING PROCEDURE
www.usaprocom.com
12. Press the LEARN BUTTON on the front of
the remote receiver box until you hear a
beep (see Programming the Remote and
Receiver, page 23).
13. Press the ON button on the remote control
transmitter to light the burner. (This will
also "learn", or program, the transmitter
and the receiver).
Note: If the transmitter is lost or damaged,
the slide switch on the receiver can be
used to operate the heater.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
WARNING: If input gas
type is NG, make sure NG pilot
burner ignites. If input gas type
is LP, make sure LP pilot burner
ignites.
Shutting Off Burner Only (pilot
stays lit )
Turn control knob clockwise
PILOT position.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
4. Make sure the heater screen is in place
before operating heater.
to the
200015-01B