Cedar Ridge CRHEB24RT Owner's Operation And Installation Manual page 18

PRESSURE TESTING HEATER GAS CONNECTIONS
1. Open equipment shutoff valve (see Figure
15, page 17).
2. Open main gas valve located on or near
gas meter for natural gas or open pro-
pane/LP supply tank valve.
3. Make sure control knob of heater is in the
OFF position.
4. Check all joints from equipment shutoff
valve to control valve (see Figure 16 or
The remote receiver operates on four AA size
batteries (included). Use ALKALINE batteries
for longer battery life and maximum micropro-
cessor performance.
IMPORTANT: New or fully charged batter-
ies are essential for proper operation of
the remote receiver as the solenoid power
consumption is higher than standard remote
control systems.
Figure 18 - Attaching Remote Receiver to Solenoid Valve
18
INSTALLATION
INSTALLING REMOTE RECEIVER
Red and Black
Wires from
Solenoid
Red and Black
Valve
Wires from
Receiver
www.usaprocom.com
17, page 17). Apply a noncorrosive leak
detection fluid to all joints. Bubbles form-
ing show a leak.
5. Correct all leaks at once.
6. Light heater (see Lighting Instructions on
page 21). Check all other internal joints
for leaks.
7. Turn off heater (see To Turn Off Gas Ap-
pliance, page 22).
1. Remove battery cover on receiver as
shown on the box. Install four AA size
batteries into receiver, (see Figure 18).
2. Locate red and black wires from solenoid
valve on right side of heater. Connect
wires to receiver, red to red, black to black,
(see Figure 18).
3. Place receiver to the side of the log set,
(see Figure 18).
Receiver
200015-01B