I M 11. Cleaning The Sensor Plate (If Necessary); Electrodes; M 13. Burner Installation On The Burner Housing - Viessmann VITOFLAME 200 Service Instructions Manual

Gas pressure jet burner (type vga) for vitola and vitorond 200 rated output 15 to 63 kw

Hide thumbs Also See for VITOFLAME 200:

Table of Contents

Initial start−up, inspection and maintenance

Implementation

nspection

(cont.)

11. Cleaning the gas outlet holes in the sensor plate

aint.

12. Checking, adjusting and replacing ignition and ionisation electrodes (if necessary)

aint.

13. Burner installation on the burner housing

aint.

1. Remove the cables from the

electrodes H and

2. Loosen the electrode holders K

and A, and remove the ignition

and ionisation electrodes.

3. Remove the nut from the earth

electrode F and unscrew the

electrode.

4. Unscrew the Allen screws from

the sensor plate E.

5. Remove the sensor plate E, the

spring washer D and the end

plate C from the mixer

assembly B and clean.

6. Installation in reverse order.

Please note:

For alignment of the end plate C

and electrodes F, G and H see

page 23.

For setting values see page 23.

(if necessary)

Table of Contents