General Information - Viessmann VITOFLAME 200 Service Instructions Manual

General Information

Safety instructions
Please follow these safety instructions closely to prevent accidents and material losses.
Work on the equipment
Installation, initial start−up,
maintenance and repairs must only
be carried out by a competent
person (heating engineer/
installation contractor) (EN 50 110,
part 1, and VDE 1000, part 10 or local
regulations).
Before working on the equipment/
heating system, isolate the mains
electrical supply (e. g. by removing a
separate mains fuse or by means of
a mains electrical isolator) and
safeguard against unauthorised
re−connection.
Disconnect the system from the
mains electrical power by means of a
device which simultaneously isolates
all non−earthed conductors with at
least 3 mm contact separation.
When using gas as fuel, also close
the mains gas shut−off valve and
safeguard against unauthorised
re−opening.
Work requiring the control unit to be
opened must not subject internal
components to electrostatic
discharges.
Applicability
Operating and service documents
1. Complete and separate the customer registration card:
H Hand the system user this part
for safekeeping.
H Keep the heating engineer
portion.
2. Keep all parts lists, operating and
service instructions in the folder
and hand this over to the system
user.
2
Work on gas equipment
This must only be carried out by an
approved installer.
Observe all commissioning work for
gas installations specified by
TRGI '86/96 or TRF 1996 or local
regulations.
Repairs
It is not permitted to carry out
repairs on components that fulfil a
safety function.
Use only original Viessmann spare
parts or equivalent, which have been
approved by Viessmann.
Initial start−up
This must be carried out by the
system installer or a commissioning
engineer designated by him; all
actual values should be recorded in a
commissioning/service report.
Applicable to burners from serial no.:
7143681 1 00001 kkk
7143682 1 00001 kkk
7143683 1 00001 kkk
7143684 1 00001 kkk
7143685 1 00001 kkk
7143686 1 00001 kkk
7143687 1 00001 kkk
7143688 1 00001 kkk
Instructing the system user
The system installer must hand the
operating instructions for this
system to the user and instruct
him/her in the operation of the
system.
¨ Safety instructions
In this instruction manual, this
heading denotes information which
must be observed to prevent
accidents and material losses.
¨ Caution
In this instruction manual, this
caption denotes actions that must be
avoided to prevent accidents and
material losses.
This symbol is a reference
to other instructions which
must be observed.