Other Epg Functions - go sat GS3260 User Manual

TV OPERATION
If the TV has not received a time stamp for a long time, the internal clock may not match the real
time. This may result in inaccuracies in scheduled actions. To synchronize the TV, turn it on and wait
a moment, it will be performed automatically.

8.1 Other EPG functions

• Use the QBAR button to call up a table with EPG filtering settings according to your prefe-
rence.
• Use the yellow button to display a list of scheduled tasks.
• Use the red button to add a new task to the timer using displayed options.
• All timer actions must be saved in the schedule and confirmed. If there is a conflict while saving
the schedule, the TV will notify you. Scheduled actions can be edited and viewed by pressing
EPG / Schedule List (yellow button).
EN 20
9. Troubleshooting
The following table lists possible problem solutions.
Warning!
If the troubleshooting below does not solve the problem, do not attempt to repair
the TV yourself! Repairs may be carried out only by an authorized service center or
a qualified person! Other actions are in violation of the warranty terms! There is a dan-
gerous voltage present under the TV cover, which can cause personal injury, electric shock, life
hazard, or death. Improper TV handling also creates a risk of fire or other property damage and
the use of the TV is not considered safe!
Contact your dealer or Tipa s.r.o. for service options and information. Alternatively you
can visit www.gosat.com.
Check the power cord connection.
Unplug the power cord for 60 seconds, then plug it back in and try to switch
The TV does not
on the TV.
turn on
Try to turn on the TV via the ON / Menu button located on a control panel
below the display.
Check the antenna cable or video signal source.
Try changing the graphic output settings of the connected device.
No image or unusual
Adjust the TV picture settings or reset the settings.
image
Switch to another channel. There may be a temporary loss of signal or technical
difficulties on the provider's side.
Increase the TV audio volume. Check that the „MUTE" function is not activated.
Check the audio settings on the TV and connected devices.
Check the cable lines and connections.
No sound, or low
Try switching to another channel. There may be technical difficulties on the
audio volume
provider's side.
Headphones may be connected to the TV. Unplug them and check that the head-
phone output is not used. When using a DVI / HDMI adapter, the audio signal
must be transported separately if the source device does not support audio
transmission via DVI.
Verify the antenna installation and the quality of signal reception.
Sound is OK, but there is
Try switching to another program.
no image, or the image
Check the graphic output settings of the connected device.
is unusual
Check the cable lines and connections.
Verify the antenna installation and the quality of signal reception.
Atmospheric influences can cause signal interference.
The image is checkered,
decaying, or showing Try switching to another program.
defects
Switch off nearby electrical appliances which may cause interference to the TV
set during operation. Do not use high power appliances near the TV.
Check the video input signal, change its resolution or aspect ratio.
The image is not
displayed full screen
Make sure the TV screen is not resized using the ZOOM function.
TROUBLESHOOTING
EN 21