Zephyr Breeze II Use, Care And Installation Manual page 18

www.zephyronline.com
BREEZE I, AK11xx
REPLACING LIGHT BULBS
CAUTION: Light bulb becomes extremely hot when turned on.
DO NOT touch bulb until switched off and cooled. Touching hot bulbs could cause serious burns.
Make sure all power is turned off and bulbs are not hot.
Remove by turning bulb counter clockwise. Note: Bulb does not unscrew; it turns 60 degrees, stops and falls out.
If bulbs are difficult to turn due to prolonged use, firmly attach a glass suction cup approximately the diameter of the
bulb or use a rubber/latex glove and turn counter clockwise.
Replacement bulbs are available at most hardware stores or from www.zephyronline.com
Purchase type MR16 (GU-10) 35W halogen.
BREEZE II, AK12xxBx
LED LIGHT STRIPS
In the unlikely event that your LED strip fails, please contact Zephyr to order replacement parts.
See list of parts and accessories page for part #'s and contact information.
To replace LED light strip
1. Remove aluminum mesh filters.
2. Remove light panel by two screws.
3. Disconnect LED light strip quick connector.
4. Push in the two side clips on the ends of the LED strip.
5. Push LED light strip through the light panel opening.
Breeze II, AK12xxBx
Breeze I, AK11xx
Push the clip
16