Table of Contents
Advertisement
4 – MOUNTING AND INSTALLATION
4.4 Hydraulic connections
Exhausted
discharge
Plumb
to
pressure
side
of
vessel
fresh water
system
Pressurized fresh water valve
Elecrovalve
5 micron filter
Swan neck upward - Discharge
Watermaker
Fresh water outlet
All the hydraulic connections (to exception of the fresh water production) have to be realized with a 16 mm.
int. diam. hose and a ½" holder. The hydraulic section that is continuously under consistent pressure is the
pump outlet – 5 m. filter – watermaker inlet connections . For this section is necessary to use a good quality
PN 10 min. reinforced hose. An inadequate hose could burst, jeopardizing seriously the safety of the vessel.
The hydraulic connections are:
THE PRESENT MANUAL BELONGS TO -
"Armorvin"
type hose
int. dia. 16
mm.
HYDRAULIC CONNECTION AND HOSES
FIG. 4-1
Schenker Italia
22
COD: 60S12/24.B.2021
Reinforced hose
PN16 min int. dia.
16 mm.
Pump
Non return valve
Mesh filter
Water inlet
Active carbon filter
- ALL RIGHTS RESERVED
EN
Advertisement
Table of Contents
