Identification Of The Unit; Legislative Reference; Directives And Standards Concerning Machine Safety; Respect For The Environment - Requirements For Removal And Disposal - Schenker SMART 60 Installation, Use And Maintenance Manual

2 - GENERAL WARNINGS & INFORMATION TO THE RECIPIENT C

2.4 Identification of the unit

All the watermakers manufactured by Schenker Italia can be identified by a serial number printed on a label
which is pasted upon the aluminium frame near the manometer. The same serial number is also recorded on
the central black block of the energy recovery system (ERS).

2.5 Legislative reference

2.5.1

Directives and standards concerning machine safety

•
Machinery Directive 2006/42 / EC, in force since December 29, 2009;
•
Low Voltage Directive 73/23 / EEC and subsequent amendments and additions: 93/68 / CEE
implemented by the Law of 18 October 1997 n. 791.
•
Electromagnetic Compatibility Directive 89/336 / EEC and subsequent amendments and additions:
93/31 / CEE implemented with D.L. December 4, 1992 n. 476.
•
Standards UNI EN 292/1 and 292/2 (safety of machinery);
Respect for the environment – requirements for removal and disposal
2.5.2
ATTENTION
Removal and disposal of materials, as result of the decommissioning of the machine, must be
performed in accordance with the regulations in force, for the safeguard and protection of the
environment
With regard to removal and disposal, it should be noted that the materials of which the machine is made of are
not of a dangerous nature and consist essentially of:
- Stainless Steel;
- Aluminium;
- Plastic;
- Carbon fibre;
- Motors, cables and consumable electrical materials;
- Rubber and polyurethane seals.
THE PRESENT MANUAL BELONGS TO -
Serial number
Fig. 2-1
Schenker Italia
- ALL RIGHTS RESERVED
7
OD: 60S12/24.B.2021
EN