Sharp WJ-500 Operation Manual page 9

CLEANING AND CARE
INSTALLATION
P R O C E D U R E
1
Fill in the usage start year/month/day on the
label for the cartridge.
2
Wipe off the water on
the interior surfaces of
the unit with a dry towel.
Match the position of
the guide mark of the
cartridge (▲) and the
unit (▼).
Then turn the cartridge clockwise until the
LOCK mark of the fi lter cartridge (
front of the guide mark of the unit (▼).
3
Fit the cartridge into
the cartridge-catcher.
Remove the towel
which is between the
bottom of cartridges
and the unit.
4
Attach the front cover.
Insert 5 hooks of the front
cover to the hook-openings
on the main unit. Slide the
cover downward.
5
Run the water through the unit. See "Initial Use"
on page E-5.
NOTE:
Make sure to set AC and UF in each correct position.
DISPOSAL OF FILTER CARTRIDGES
Dispose of the replaced cartridges according to local
disposal laws and regulations.
Case: Acrylonitrile butadiene styren (ABS)
O-ring: Rubber
Ultra fi lter: Polypropylene (PP)
Activated carbon fi lter: Activated carbon
WJ-500 En.indd 7 WJ-500 En.indd 7
Replacement of Tubes
REMOVAL FROM THE UNIT
1
Pull out the joint while pushing down upper
end of the joint socket (blue, red, black).
2
a. For inlet/outlet tube
Pull out the tube while
pushing the end of the
joint. Refer to the fi gure.
) is in
b. For drain tube
Pull out the tube from the
joint.
Cartridge
NOTE:
If the unit is wall mounted, place it on the countertop
Cartridge
before carrying out steps 1-2 above.
catcher
REMOVAL FROM THE DIVERTER VALVE
1
Remove the nut from the diverter valve, and
pull the tube out of it.
NOTE:
Keep the nut for installation.
INSTALLATION TO THE UNIT
1
a. For inlet/outlet tube
Insert a new tube into
a joint securely. Make
sure that you cannot pull
the tube out of the joint.
Refer to the fi gure.
b. For drain tube
Insert the joint into a new
tube securely.
2
Insert the joint into a joint socket in the correct
position.
INSTALLATION TO THE DIVERTER VALVE
1
Put a new tube through the nut and connect
the tube to the correct position of the diverter
valve. Then tighten the nut securely. See
"Connecting the Tubes" on page E-4.
E – 7
P R O C E D U R E
P R O C E D U R E
P R O C E D U R E
P R O C E D U R E
2011/10/20 10:54:04 2011/10/20 10:54:04