Sharp WJ-500 Operation Manual page 6

IMPORTANT INSTRUCTIONS
Connecting the Tubes
Caution: Connect the tubes correctly. If you
connect any tubes to a wrong position, water
will not fl ow from the faucet for purifi ed water.
Do not bend the tubes.
P R O C E D U R E
1
Once the joint of tube is inserted into the joint
socket, you cannot change the direction of
the tube. Be careful of the tube direction as
all tubes are led together to the outside of the
unit at step 3.
Insert the joint of tube (A) to the "IN (black)"
joint socket at the bottom of the unit.
Insert the joint of tube (B) to the "OUT (blue)"
joint socket at the bottom of the unit.
(A)
2
Insert the joint of tube (C) to the "DRAIN (red)"
joint socket at the bottom of the unit.
3
Lead the 3 tubes together to the outside of the
unit.
WJ-500 En.indd 4 WJ-500 En.indd 4
(A)
(B)
(C)
(B)
(C)
E – 4
4
Remove the nuts from
the tap water outlet and
purifi ed water inlet of the
diverter valve.
5
Put 2 tubes through each nut, and connect the
tube (A) to the tap water outlet (10-1) and tube (B)
to the purifi ed water inlet (10-2) of the diverter
valve. Then, tighten the nuts securely.
NOTE: You can adjust the tube length by cutting
it, if necessary. Make sure that the cut surface is
straight and right angle.
(10-1)
(10-2)
6
Attach the sucker of the
tube (C) onto the sink.
Place the end of the tube
(C) in the position which
is lower than the bottom
of the unit.
7
Check that all tubes have connected correctly,
referring to TIPS on page E-5.
NOTE:
Use the bands to gather the tubes together, if necessary.
Installation for Wall Mount
1. When you install this unit to the wall, it should be
mounted against and supported by a fl at vertical wall.
2. T h e m o u n t i n g s u r f a c e m u s t b e c a p a b l e o f
supporting the total weight of the unit with its full
capacity (4.4 kg.)
3. Prepare 2 screws for hanging
the unit. Drill 2 holes for the
screws in the wall.
4. Tighten the 2 screws into the
holes, and hang mounting
holes of the unit onto the
screws.
12-15mm
10-12mm
5mm
NOTE:
Wall mounting may cause scratches to the back of the
unit.
190 mm
Wall
6mm
2011/10/19 17:08:18 2011/10/19 17:08:18