Printing A Tag; Labelase  Producer Software - InfoSight LabeLase 28 Series Basic Operations & Maintenance Manual

PRINTING A TAG

Note - The following assumes the LabeLase
There are several ways to print a tag using the LabeLase
A) If tag stock is loaded in the machine from the rear payoff reel and properly aligned at the break off
exit point:
1. Pressing the PRINT button located beside the red E-STOP will initiate printing of 1 or
more tags, depending on operator-entered data on the main Producer
2. Pressing the F12 key on your PC.
3. Use the mouse to click Accept and Begin Print button on your PC.
4. A print command may be sent from your host computer to your PC via Extended
Protocol.
B) If there is no tag stock feeding in from the side of the machine, a single tag inserted in the SIDE slot
will be automatically drawn into the printer.
5. If the AUTO PRINT SINGLE ITEMS box is checked (enabled) in the SETUP / PRINTER
CONFIGURATION menu (requires supervisor login), then tag printing will begin
automatically with no further action or input required.
6. If the auto print box is NOT checked, then any of the above methods in paragraph (A) may
be used to initiate printing.
CAUTION: DO NOT GRIP THE TAG STOCK BY ITS EDGES WHEN FEEDING
INTO THE PRINTER. PROTECT YOUR HANDS AND FINGERS FROM THE
SHARP EDGES OF THIN METAL TAG STOCK AT ALL TIMES.
NOTE: The SINGLE PRINT feature of the printer requires a minimum tag or
For example, a single 3x3 (or 3x4, 3x6, etc) tag may be printed. If single
printing of a 3x1 (76 x 25mm) tag is desired, a strip of at least 3 tags must be
LL28XX Tag Printer Copyright © 2003-2021 InfoSight Corporation All Rights Reserved

28XX Tag Printer has already been setup with a tag layout.

28XX.
tag-strip length of three inches (76mm).
inserted in the side slot.
TM
screen.
Page 5