Table of Contents
Advertisement
STARTUP SEQUENCE:
1.
Attach the preferred communications cable from the
LabeLase
28XX Tag Printer to your Windows-based
PC running LabeLase
2.
Install tag stock onto tag payoff reel
3.
Insert the AC power cord into a nearby power
receptacle.
4.
Place the security key in the machine, The key
functions as an ON-OFF switch.
5.
Turn key to the horizontal (ON) (I) position. NOTE: The
security key can only be removed when in the OFF
position.
Side Panel, toward the bottom
6.
Remove E-STOP by pulling the red button.
7.
Feed tag stock into printer. If necessary, press the tag
FEED button to align tags to the breakoff location.
8.
Start LabeLase
Producer software on your PC.
9.
Load a pre-existing tag layout, or design a new tag
layout. NOTE: designing or changing a tag layout
requires SUPERVISOR login.
10. Adjust printer setup parameters if necessary (e.g., laser
speed). NOTE: other than setting laser speed
(LIGHTER/DARKER slider bar), this feature requires
SUPERVISOR login.
NOTE: The Producer software is password protected for all features beyond loading an
existing tag layout, entering tag variable data, adjusting laser speed and initiating printing.
The default password for new installations is blank (no data, no spaces). A new password
should be created before printer is commissioned for regular operator use.
LL28XX Tag Printer
Copyright © 2003-2021 InfoSight Corporation All Rights Reserved
Producer software.
3
4/5
Front Panel
1
7
6
Page 3
Advertisement
Table of Contents
