Table of Contents
Advertisement
SYSTEM STARTUP
The Power requirements for the LabeLase
requirement. By looking at the label plate at near the power entry you can determine whether the unit is:
•
120 VAC, 50/60HZ fused at 10 Amps or
•
240 VAC, 50/60 Hz, fused at 5 Amps.
WARNING: 220V models both sides of the incoming line voltage are fused.
Recommended AC plug type is :
Woodhead 1447 for 110V
Use a properly approved IEC 309 plug for 220V power connection.
Note: Complete AC Disconnect is accomplished at the power plug.
The LabeLase
28XX Tag Printer should be positioned so that the power supply cord exits from the left side
of the machine.
The LabeLase
28XX Tag Printer should be placed in a temperature controlled environment. This marker,
though designed for industrial use, should be treated as any typical computer system and printer. Dirty
environments will necessitate more frequent cleaning for internal optics.
A 12-foot (3.6 meter) RS-232 serial communications cable and a USB communications cable are provided
for communicating with your Windows-based PC. Use only one cable.
AFFIXING THE LL28XX TO SOLID PLATFORM
Important:
The LL28XX support legs are designed to be anchored to the floor or concrete to prevent the unit from
tipping over in the unlikely event of a force exerted upon the side surfaces of the units. Incorporated in the
design of the support legs are 4 x 33/64" thru-holes. These four thru-holes are to have placed through them,
suitable anchor bolts to affix the LL28XX to the floor. The type of anchor bolt used will depend upon the
base material the LL28XX will be set upon. Recommended anchor bolts are listed below.
Note:
Anchor bolts used are to withstand a tension weight of at least 50 lbs. each.
Manufacture
Description
------------------------------------------------------------------------------------------
Hilti
KB II 38-3 3/8" Kwik bolt
Cast in place 3/8-16UNC 2"
3/8" x 2" Lag bolts
3/8" x 4 " J bolts
LL28XX Tag Printer
Copyright © 2003-2021 InfoSight Corporation All Rights Reserved
28XX Tag Printer differs according to the as built customer
Floor type
Concrete
Concrete
Wood
Steel Grating
Page 1
Advertisement
Table of Contents
