Nvidia nForce 650i User Manual page 39

Based m/b for lga775 quad core ready intel core processor family
Hide thumbs Also See for nForce 650i:
Table of Contents

Advertisement

Enabled (default)
Disabled
Note:
The L1 & L2 cache is built in the processor.
Quick Power On Self-Test
This category speeds up Power On Self Test (POST) after you power on the computer. If
this is set to Enabled, BIOS will shorten or skip some check items during POST.
Enabled (default)
Disabled
First/Second/Third/Fourth Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected in
these items. The settings are Floppy, LS/ZIP, HDD-0/HDD-1/HDD-3, SCSI, CDROM,
LAD and Disabled.
Boot Up Floppy Seek
During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks.
360K type is 40 tracks while 760K, 1.2M and 1.44M are all 80 tracks.
Boot Up NumLock Status
The default value is On.
On (default)
Off
Keypad is arrow keys.
Gate A20 Option
To control the CPU A20 address with chipsets controller by selecting "Fast" selection and
with keyboard controller by selecting "Normal" selection.
Typematic Rate Setting
Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected. The settings are: Enabled/Disabled.
Typematic Rate (Chars/Sec)
Set the number of times a second to repeat a keystroke when you hold the key down. The
settings are: 6, 8, 10, 12, 15, 20, 24, and 30.
Typematic Delay (Msec)
Sets the delay time after the key is held down before is begins to repeat the keystroke. The
settings are 250, 500, 750, and 1000.
Security Option
This category allows you to limit access to the system and Setup, or just to Setup.
System
Setup (default) The system will boot, but access to Setup will be denied if the correct
MPS Version Control For OS
This option is only valid for multiprocessor motherboards as it specifies the version of the
Multiprocessor Specification (MPS) that the motherboard will use.
Enable cache
Disable cache
Enable quick POST
Normal POST
Keypad is numeric keys.
The system will not boot and access to Setup will be denied if the
correct password is not entered at the prompt.
password is not entered prompt.
1.4
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nforce 430

Table of Contents