Start-Up - Kenwood M-9000S Operating Instructions Manual

2. Start-up

2.1 Unpacking
Carefully unpack the device and make sure all accessories are present:
• Infrared remote control
• FM/DAB+ wire antenna
• 2 x AAA/R03 batteries
• Operating instructions
• 2 x speakers
2.2 Connect
• Open the battery compartment of the remote control and insert the batteries w. correct polarity.
The specified polarity (+/-) is marked in the battery compartment.
Connect the left and right speakers to the connection (Speaker Out) on the rear of the device. To do
this, press the spring clips and insert the loose cable ends into the openings provided. Connect the
black wire with the black spring clamp. The other wire is connected to the red terminal in the same
way.
• Finally, connect the power plug to an AC outlet. Since the mains plug is used to completely
disconnect it from the power grid, the socket must always be accessible.
2.3 DAB+ / FM antenna connection
1. Connect the wire antenna to [FM ANTENNA 75Ω] socket.
2. Find the place where the best reception is achieved.
3. Fix the antenna.
The antenna supplied with the system is a simple wire antenna. It is recommended to use an outdoor
antenna (commercially available) for stable signal reception.
To connect an outdoor antenna, first pull out the indoor antenna.
The reception of radio stations from the cable network cannot be guaranteed.
6
Speaker cable Black/grey
Black