Lightcloud LCCONTROL20/D10 Manual page 10

4 Power Up
To add new devices to your Lightcloud network, call RAB at
1 (844) LIGHTCLOUD, or email us at support@lightcloud.com.
Confirm Device Connectivity
5
Confirm Status Indicator is Solid Green (see details below)
6 Commission your devices
Log on to www.lightcloud.com or call 1 (844) LIGHTCLOUD
DEVICE IDENTIFICATION BUTTON
• Illuminated when device is powered
• Press once to highlight this device in the
Lightcloud Application
• Press twice to toggle circuit on and off
• Press twice and hold to set dim level
• Press and hold for 10 seconds to remove
this device from a Lightcloud network
• Blinks when device is indicated from the
Lightcloud Application
SIGNAL INDICATOR
Illuminates when the device receives a message
and indicates the strength of the signal.
3 - Best signal
2 - Acceptable signal
1 - Unacceptable signal
Consult the "Finding a Location" section
for more information.
STATUS INDICATOR
Solid GREEN when connected to your Lightcloud
network. Blinking RED when not connected.
The device will automatically continue trying to
connect to a network in Setup Mode.