Demo (Demonstration) Mode; How To Set Demo Mode; How To Exit Demo Mode - Hitachi DZMV238EAU Service Manual

8.

Demo (Demonstration) Mode

This section explains the demo (demonstration) mode equipped with this DVD video camera/recorder.
Perform the following procedures after turning DVD video camera/recorder on and opening the LCD monitor (while viewing
LCD screen). Use the buttons, etc. on this DVD video camera/recorder for all operations.

8.1 How to set demo mode

Before starting:
Use the joystick to move the cursor to a menu item, and then designate it when the Disc Navigation is in operation.
(Tilt up, down, to left or right to move to an item, and press the center of joystick to designate the item.)
Operational procedure:
1) Set the power switch to "POWER OFF".
2) Connect the AC adapter or fully charged battery as the power supply.
3) Set the power switch to "VIDEO".
4) Press the MENU button to display the camera menu screen.
5) Choose "Initial Setup", "Demo Mode" on the camera menu screen, and then designate it.
6) Choose "Start" on the Demo Mode setting screen, and then designate it.
Notes: 1) Specifying "Demo Mode: Auto" will automatically set the camera/recorder to the demo mode in the following
status:
When the DVD video camera/recorder without a disc loaded is left without being operated for at least
3 minutes after it is turned on (except during playback/recording)
2) During the demo mode, the recording indicator blinks and no operation other than the following is accepted:
Power switch
Stop/cancel button
DISC EJECT button
MEMO button
DISC NAVIGATION button
3) The demo mode will not operate when the camera/recorder is connected to PC.

8.2 How to exit demo mode

Note: To end the demo mode, perform any of the following operations: If "Demo Mode: Auto" is specified, the demo mode
will automatically start again in the above status even if it has stopped once.
Set the power switch to "POWER OFF".
Press the stop/cancel button.
Press the DISC EJECT button.
Before starting:
Use the joystick to move the cursor to a menu item, and then designate it when the Disc Navigation is in operation.
(Tilt up, down, to left or right to move to an item, and press the center of joystick to designate the item.)
Operational procedure:
1) Set the power switch to "POWER OFF".
2) Connect the AC adapter or fully charged battery as the power supply.
3) Set the power switch to "VIDEO".
4) Press the MENU button to display the camera menu screen.
5) Choose "Initial Setup", "Demo Mode" on the camera menu screen, and then designate it.
6) Choose "Off" on the Demo Mode setting screen, and then designate it.
1 - 15