Rear Block, Ref Circuit Board, Camera Block, Man Circuit Board, Circuit Board Frame, Drf Circuit Board, And Hot Shoe - Hitachi DZMV238EAU Service Manual

4.4 Rear block, REF circuit board, Camera block, MAN circuit board, Circuit board frame,
DRF circuit board, and Hot shoe (Fig. 4-4)
Caution when disassembling:
Be careful not to damage the flat cable on rear block.
Be careful not to damage the camera block (lens), and that no foreign object, such as dust, enters the lens.
Be careful not to damage the plugs (PG0501 and CN1501) between REF and MAN circuit boards.
Rear block (A)
(1) Remove the four screws holding the rear block.
(2) Disconnect the three flat cables on REF circuit board.
(3) Disconnect the flat cable on MAN circuit board.
REF circuit board (B)
(4) Remove the screw holding the REF circuit board.
(5) Move the REF circuit board in the direction of the arrow to disconnect the connections (PG0501 and CN1501) from
the MAN circuit board.
(6) Remove the REF circuit board in the direction of the arrow.
Camera block (C)
(7) Remove the screw holding the circuit board frame and ground cable.
(8) Disconnect the three flat cables on MAN circuit board.
(9) Remove the three screws holding the camera block.
MAN circuit board (D), Circuit board frame (E), DRF circuit board (F)
(10) Disconnect the one flat cable, connector of DRF circuit board and one connector on MAN circuit board.
(11) Remove the screw holding the MAN circuit board.
(12) Remove the MAN circuit board in the direction of the arrow.
(13) Remove the circuit board frame in the direction of the arrow.
(14) Remove the DRF circuit board in the direction of the arrow.
Hot shoe (G)
(15) Remove the screw holding the hot shoe.
(16) Remove the hot shoe in the direction of the arrow.
Caution when reinstalling:
Securely connect the flat cables and connectors.
Securely connect the plugs (PG0501 and CN1501) between REF and MAN circuit boards.
Install the circuit board frame in the specified position.
A : Rear block
B : REF circuit board
C : Camera block
D : MAN circuit board
E : Circuit board frame
F : Hot shoe
G : DRF circuit board
H : Ground cable
2 - 12
(1)
[Bottom view]
[Type-c]
C
F
(14)
(13)
E
(1)
(9)
(10)[Type-a]
(9)
D
(7)
H
Fig. 4-4
(1)
G (1)
(16)
(15)
H
(8)[Type-a]
(10)[Type-c]
CN1501
(3)[Type-a]
(10)
(11)
(5)
(12)
B
PG0501
A
(4)
(2)[Type-a]
(2)[Type-b]
(2)[Type-c]
(6)