Advertisement
Use correct blades. Do not use blades with incorrect size holes. Never use blade washers or bolts that are defective or incorrect.
Refer to unit specifi cation for maximum blade capacity etc.
Inspect and remove all nails from timber before cutting.
Never touch the blade or moving parts during use.
Never start the saw when the blade is in contact with the workpiece.
Keep handles and grasping surfaces dry, clean and free from oil and grease.
LASER LIGHT. LASER RADIATION DO NOT stare into beam. Only turn laser beam on when tool is on work piece.
2. INTRODUCTION
Powerful 2000W motor. Features integral aluminium workpiece supports which store inside the aluminium base to save space and prevent
loss. Fitted with a 40-tooth TCT blade for fresh wood. Can be fi tted with Model No. SMS255B multipurpose blade for use with mild steel,
aluminium and wood with nails. Features double slides which can be locked at diff erent lengths allowing greater control over the desired length
of cut. Max cut of up to 315mm at 0° bevel. Unit is also fi tted with a laser guide to help produce accurate cuts. Supplied with workpiece clamp,
dust extraction bag and fi tted with carry handle. Features locking increments at mitre stops 0°,15°, 22.5°, 30°, 45° Left & Right.
3. SPECIFICATION
Model no ............................................................. SMS255.V3
Blade size ...................................Ø254 x 2.8 x Ø30mm (40T)
Consumable Parts: ............................................. ...SMS255B
Multipurpose Cut-Off Saw Blade Ø250 x 2.4mm/Ø30mm 60tpu
Dust extraction port ........................ Ø35mm ID x Ø43mm OD
Motor power ................................................................2000W
No-load speed .......................................................... 5000rpm
Positive mitre lock ............0°,15°, 22.5°, 30°, 45° Left & Right
Supply ............................................................................230V
Cross Cut (0
Bevel x 0
Table) .......................... 90 x 315mm
0
0
Mitre Cut (0° Bevel x 45° Table): ........................ 90 x 215mm
Bevel Cut (45° Bevel x 45° Table): ..................... 40 x 215mm
4. COMPONENTS
fi g.1
1
Handle
2
ON/OFF Switch
Lock-off lever
3
4
Machine head
Moving blade guard
5
6
Saw blade
7
Clamping device
Workpiece support
8
9
Locking screw for workpiece support
Table insert
10
© Jack Sealey Limited
11
Turn table locking handle
12
Pointer
13
Mitre scale
14
Turn table
15
Fixed saw table
16
Stop rail
16a
Extension block
16b
Set screw
17
Sawdust bag
18
Bevel scale
Original Language Version
19
Bevel pointer
20
Locking screw for drag guide
21
Drag guide
22
Locking screw knob
23
Fastening bolt
24
Screw for cutting depth limiter
25
Stop for cutting depth limiter
26
Locking bolt
27
Support foot
28
Turn table release lever
fi g.2
29
Flange bolt
30
Outer fl ange
31
Spindle lock button
32
Inner fl ange
33
Laser
34
ON/OFF switch for laser
35
Laser compartment
36
Laser holder
37
Guide bar
38
Adjusting screw
SMS255.V3 Issue 1 21/05/21
Advertisement
