Specification - Sealey SM5.V3 Instructions Manual

waRning! never force the blade through the workpiece.
ˆ
dO nOt use this bandsaw for anything other than its intended purpose. this bandsaw is designed for light metal cutting work in
8
engineering workshops, garages, metal fabricators, etc.
waRning! the sm5.V3 bandsaw must nOt be used to cut non-metallic materials (including wood).
ˆ
dO nOt wear loose or ill-fitting clothing. remove ties, watches, rings and other jewellery. tie up, or adequately cover, long hair.
8
dO nOt start the bandsaw until the workpiece is secure and the blade has been lowered to just above the workpiece.
8
dO nOt run the bandsaw with the blade in the raised position unless set up for vertical cutting.
8
dO nOt use the bandsaw in areas where fumes from paint, solvents, or flammable liquids pose a potential hazard. Keep all
8
flammable materials (including wipes or cleaning rags) away from the saw, and dispose of according to local regulations.
dO nOt leave the bandsaw running unattended. Turn power switch 'Off' and dO nOt leave area until the blade has come to a
8
complete stop.
dO nOt use the bandsaw if tired or under the influence of drugs, alcohol or other intoxicating medication.
8
dO nOt use the bandsaw with the blade guard or pulley cover removed
8
dO nOt use the bandsaw in wet or damp locations.
8
dO nOt start accidentally. ensure the switch is off before plugging in the saw.
8
dO nOt use damaged or deformed bandsaw blades.
8
Keep correct footing and balance at all times and wear non-slip shoes.
9
turn the bandsaw off before raising the blade.
9
dO nOt stand on the bandsaw.
8
Always secure the workpiece in the vice.
9
2. intROductiOn
model no. sm5. three speed settings. oil bath gear box and life lubricated bearings for quiet, smooth operation. fully guarded blade
and magnetic no-load voltage switch. Heavy-duty cast base and horizontal/vertical cutting arm. Saw base features integral mitring
vice with scale of 45° to 90° for angle cutting and fully adjustable precision blade guides for accurate cutting and longer blade life.
stand is fitted with two transport wheels for added workshop mobility.

3. specificatiOn

model no: ....................................................................sm5.v3
capacity 90° round ..................................................... Ø115mm
capacity 90° square/rectangular H x W ..............100 x 150mm
capacity 45° round .......................................................Ø60mm
capacity 45° square/rectangular H x W ................100 x 60mm
weight ...............................................................................60kg
Blade size ................................................ 1638 x 13 x 0.63mm
Blade speeds ................................................18, 30, 48mtr/min
motor Power .................................................................... 375w
Power supply ................................................................... 230V
4. assembly
4.1. note: numbers in brackets refer to parts diagram items.
4.1.1. remove the unit from packing and check that all items in the following list are present and undamaged: saw Assembly, Pulley cover,
shelf, floor stands (2 of), stock stop & rod Assembly, Hand wheel, Vice, Axle & wheels Assembly, Handle, floor stand, Vertical
Cutting Table, Drive Belt, Bag of screws, washers, nuts, split pins.
4.2. stand assembly
4.2.1. lay a leg (4) down and fix one end of the shelf (170), using screws, see fig.1. nOte: the shelf will only fit one way -
edges facing up.
4.2.2. dO nOt fully tighten the screws yet.
© Jack sealey limited
.
fig.1
Original Language Version
fig.2
sM5.V3
fig.3
Issue:7(H, F)13/02/18