note:
For transporting the device, use the transport case included in the scope of delivery in order to protect the device from external
influences. Before transporting the device, observe the following:
Switch off the device.
9
Hold onto the mains plug while pulling the power cable out of the mains socket.
9
Allow the device to cool down.
9
Remove the tool from the tool holder.
9
Do not reconnect a defective device to the mains.
8
2. intRoDuction
Powerful reciprocating saw designed to cut various materials including metal, wood and plastics. Handle can be rotated 90° in either direction for
greater access and control when working in confined spaces. Supplied with wood cutting and metal cutting blades. Built-in quick blade change
system. Fitted with a 3mtr heavy-duty rubberised cable. durable composite housing with soft grip for added comfort.
3. Specification
Model no: .................................................................SRS850
nett Weight: ................................................................ 2.55kg
no load Speed: ................................................... 0-2800spm
Stroke ......................................................................... 28 mm
Max. cutting depth: .................................................................
Wood ........................................................................ 160 mm
Metal ............................................................................. 8 mm
Aluminium ................................................................... 12 mm
no.
description
1
Release button
2
Stroke rate setting wheel for continuous operation
3
locking switch for continuous operation
4
on/off switch/stroke rate control
5
Rotatable handle
6
Carbon brush cover
7
Guide shoe locking lever
10
Guide shoe
11
Quick-release chuck
12
led work lamp
4. Set up
4.1.
All saw blades having an S-shank or a ½'' universal shank can be
used for this device. The saw blade should not be longer than
required for the cut. A narrow saw blade should be used when
sawing tight curves.
4.2.
cHanging tHe Saw BLaDe
4.3.
Please proceed as follows to remove or insert a saw blade:
4.3.1.
Turn the quick-release chuck (fig.1.11) to the side and hold it in this position. If required, you can remove the guide shoe to reach the
quick-release chuck more easily (see Adjusting the guide shoe).
4.3.2.
If a saw blade is inserted, remove the saw blade from the quick-release chuck.
4.3.3.
Insert the saw blade into the quick-release chuck. Make sure that the teeth of the saw blade point downwards.
4.3.4.
Push the saw blade into the quick-release chuck up to the stop. Use a suitable saw blade with S-shank or ½'' universal shank.
4.3.5.
let go of the quick-release chuck. The quick-release chuck must return to its initial position.
4.3.6.
Check whether the saw blade is properly locked in place.
note:
If you turn the handle, the saw blade can be inserted rotated by 180° (saw blade teeth point in the opposite direction) to enable easier
working.
© Jack Sealey limited
fig.3
Original Language Version
fig.4
SRS850 Issue 1 28/09/18
fig.1
fig.2
fig.5